Led Wall Lights Dimmable

Hot Products

FAQ

How did the trademark on the LED bulb go up?
Laser printing and screen printing, pad printing can be, look at the needs and equipment.
What are the types of LED bulb?
According to the interface, the LED bulb has GU10, E14, E27, E40 and so on.
What's the difference between a glass cap for a bulb and a PC hood?
Transparency comparisonPC transparency is 90%, glass transparency is 95%, but the naked eye does not seem to distinguish between too big, because it is 5%, ha ha,Only several meters can be measured by instruments.
What's the reason for the LED bulb strobe?
If this resonant characteristic causes the input current to fall below the TRIAC sustaining current, the TRIAC will turn off. After a short delay, the TRIAC usually switches on and fires the same resonance. In the 1.5 cycle of the input power waveform, this series of events may be repeated several times to form visible LED flashes. To cope with this problem, a key requirement of TRIAC dimming is that the input capacitance of the EMI filter is very low and that the capacitor is decoupled through the TRIAC and the winding impedance. According to the formula, if the capacitance of the dimming module is reduced, the resistance of the resonant circuit can be increased, and the oscillation is suppressed in principle, and the desired circuit work is resumed.
How to choose the bulb power?
If it is household, choose the separation side, because the separation type is relatively safe, easier to pass through safety regulations, but the cost is relatively high, but suitable for home use.
Led what's the flash of the bulb?
The internal drive of a cheap LED bulb is generally a resistance drop, and voltage fluctuations can occur in a flash. So all 100 of you are a flash.
What is the AC voltage of the LED bulb?
The AC voltage of LED bulb is usually 220V, and the power is divided into 3W, 5W, 7W, 8W, 9W, 12W and so on.The biggest market for LED bulb lighting is the civilian market, and the LED bulb is a new green light source to replace the traditional incandescent bulb. LED lamp has the advantages of energy saving, environmental protection, long service life, no stroboscopic, green and so on.
LED bulb is broken. The luminous patch is not bad. Can it be made into USB lamp?
When electrons and holes are combined, they can radiate visible light, so they can be used to make light-emitting diodes. In circuits and instruments, as an indicator, or in combination with text or digital display. GaAs diodes glow diode gap, green silicon carbide, yellow light diode, light emitting diode gan. Because of the chemical properties and organic light-emitting diode OLED and inorganic light-emitting diode LED.