Kitchen Ceiling Light Fixtures Led

Hot Products

FAQ

Patch LED light does not flash, why?
Are you saying that lamp is flashing? You can check the power output, according to your standard parameters and SMD beads, lamp panel series parallel mode, calculate the power output to output power of the test, you may be wrong, power, overload, but also the effective part of you may be the circuit for power transmission is not stable or low
0603,0805,1206,3020,3528,5050,355 what is the current and voltage of these patch LED? Please give advice!
SMD LED specification:(1) metal stent type: 0402, 0603, 0805, 1206, 3mm, 5mm, 6mm, 8mm, 10mm and so on.(2) metal support (commonly known as small butterfly) type: 2mm, 3mm and so on.(3) TOP LED (white shell) type: 1208 (30*20), 1311 (35*28), 1312 (35*32), 2220 (55*50) and so on(4) side light LED:0905 (22*12), 1105 (28*12) 1605 (40*14) and so on.
What should I notice when I want to solder 1206 LED patch type luminous tube on fine copper wire?,
The peak reflow temperature: 260 degrees or below this temperature. (surface temperature) 2 temperature over 210 DEG C required time: 30 seconds or less than this time. 3 reflow times: no more than two times. 4 after reflow, LED needs to be cooled to room temperature before contact with colloid.
Patch LED market conditions
Chinese suppliers also offer mature, but less profitable two-color and trichromatic products, which are mostly used in backlighting, appliances, consumer products, consumer electronics and display. Despite low market demand, vendors continue to offer sideview SMD LED, including 335 (4008), 020 (3806) and 215 (2810)
What is the difference in performance between the LED plug-in and the LED patch?
The same, stick pieces is an early product, stick pieces than patch mature, stick pieces of my lamp has almost can not see what changes for three years with only a patch of brightness, years have been feeling a lot of dark. I believe the quality will be good soon.
SMD LED lamp working voltage?
Voltage range of white LED lamp: 3.0-3.4VThe pressure drop of the red LED is 2.0--2.2VThe yellow light emitting diode has a pressure drop of 1.8 - 2.0VThe green light emitting diode has a pressure drop of 3 - 3.2VThe blue light emitting diode has a pressure drop of 3.0-3.4VSMD voltage is basically the same as double lead line. Current is generally 20~60mA, and some work current can exceed 100mA.
What does "1210" mean in patch LED?
1210 represents the size of the LED package specification (size, specification), and represents the length and width of the resistanceSpeed adoption!!!
What does patch LED light mean?
The patch may be said, adding that the patch board PCB light source, light source lamp light source generally refers to, patch may refer to the combination of PCB plate and two lens beads.