Hot Products

FAQ

Patch LED light does not flash, why?
There are three main reasons:1, the temperature is too high, resulting in LED lights, dead lights.2, do not do anti-static measures, electrostatic breakdown chip, resulting in damage to the LED light.3, the use of LED lamp quality is too bad, the purchase price reasonable LED lights
How do led patches measure good or bad?
Use the two stage tube test of the multimeter, the red pen is connected, and the black pen is negative. If there is a bee, the sound is bad, and if the light is bright, it is good
The quality of the LED patch module
Quality of circuit board. In the same quality of LED, the quality of PCB will have an important impact on the life of LED. The circuit board is divided into aluminum plate, glass fiber board, semi glass fiber board and paperboard. The quality of aluminum is the best, the best cooling effect, but the cost is too high, the domestic manufacturers generally only in high-power LED products use, LED module manufacturers generally use cardboard, semi glass fiber and glass fiber board. Module, piranha, straw hat module monochrome is generally used in cardboard or semi glass, commonly used glass fiber or semi SMD glass fiber board. Colorful and full color module series generally at least half of glass fiber, so as to match.
What determines the brightness of the patch LED?
The current through the lamp itself. If the same lamp, so it is necessary to ensure consistency in the different current circuit, the test voltage of little significance, especially in the case of parallel lamp, current a few beads each share is not the same, some big, some small.
What is the difference between patch LED beads and LED beads: General
A pin of the lamp, and outside a resin cap, because the reason LED beads can spotlight cap;There is no pin on the patch and there is no resin cap outside. Because of the lack of cap, the LED patch can not be concentrated.LED patch lamp is made of FPC circuit board, LED lamp and high quality silica gel sleeve. Waterproof performance, using low voltage DC power supply is safe and convenient, light colors, bright colors; outdoor use can be anti UV aging, yellowing, high temperature resistance and other advantages, the products are widely used in building lights, decorative lighting, advertising and entertainment quasi decorative lighting lighting field.
LED package and LED SMD LED lamp, what is the difference? Will the release agent be used in that part?
Packaging is for TOP series LED, that is, the type of plastic molding. The patch is based on the PCB circuit board for molding. Mold release agent is used in molding.
What is the principle used in SMD LED lamp, should pay attention to what the problem?
Table 1, contact electrostatic protection LED product should be covered with protective electric tape, and its reliable grounding; 2, personnel shall wear groundstrap in contact with LED (best for cable, protective gloves, anti-static ring) allows better wear anti-static clothing, anti-static shoes and static electricity cap; 3, the application in the process of exposure to LED equipment must be reliable grounding, such as iron, shearing machine, bending machine and welding equipment. Conditional still can install plasma fan to eliminate electrostatic; 4, in use or when designing electronic circuit, must consider the harm that excessive current has to LED
What does patch LED light mean?
The patch may be said, adding that the patch board PCB light source, light source lamp light source generally refers to, patch may refer to the combination of PCB plate and two lens beads.